- Download the file ezicad.exe using the link
below and save it to your local hard drive AFTER you
have read these notes
- 'Run' ezicad.exe to start the Installation.
You can achieve this by using Explorer or My Computer to
locate 'ezicad.exe' and double click it.
The installation will suggest a default location to
install the Ezicad files, and we suggest that you accept
this default location unless you have some particularly
important reason to do otherwise.
- Configure Ezicad to the distance and angular
units, and coordinate display configuration that you
like/need to use in your particular location.
Once Ezicad is installed, run it and open a New Job.
Next Access the “Modes” either by selecting the button 
on the toolbar, or by pressing the F9 function key.
Then click on the ‘tab’ titled Modes Input.
Here you can set whatever distance
and angular units you like, and then click the Modes
Display tab to specify (bottom left corner) if
coordinates should be input and displayed with North first,
or East first.
Once done, close the job.
Ezicad will now remember these settings, and default to them
when you open a new job.
Click
Here to start downloading Ezicad.
We look forward to helping
you improve your
efficiency.
Important
Warning to Norton SpeedDisk Users
(or other utilit
ies
that move hidden system files)
Speed Disk is the defragmentation utility
included in Symantec's Norton Utilities.
Unfortunately, Speed Disk moves hidden system files which
includes Ezicad licensing files, causing license loss.
If you use Norton Utilities Speed Disk, you MUST
do the following steps Before Speed Disk runs or you will lose
your Ezicad License.
1. Open Speed Disk and choose File, Options,
Customize and Unmovable Files
2. Specify that *.ent, *.rst and *.key
files cannot be moved.
3. Choose File Options, Optimization, and Save
to save the changes.
